Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

HH-210 with DP3035 Tomorrow

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • HH-210 with DP3035 Tomorrow

    I'll be ordering the HH-210 with DP3035 spool gun tomorrow morning. Does anyone have any idea if I can buy a regular 3035 spool gun extension kit (25' cable-extension kit) to use with the DP3035? I realize I'd have to extend it on the gun-end as opposed to the welder-end, but will it work?

  • #2
    As far as I know, no, you can't. The DP spool gun uses a different set up for the connection. It may be possible with extensive change outs and modifications, but as a plug and play, no.

    I am very sure you will be quite happy with that setup. I have been using mine for over a year now and am still extremely pleased with the way it works. When I recieved the field test unit, I wasn't thinking it would be anywhere near as good as my MM210. It was a very pleasant surprise to see it not only was as good, but even better in many respects. Aluminum was one of the even better areas.


    Special Offers: See the latest Miller deals and promotions.