Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Pipe Slip fit for collers

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pipe Slip fit for collers

    Does anyone know what schedule 40 pipe size would be the best slip fit for collars to make hinges for gates to be hung on 2" schedule 40 pipe.

    Also same for 3" schedule 40 pipe.


  • #2
    2-1/2 sch 40 and 3 1/2 sch 40.


    • #3
      I use 2" sch80 outside & & 1-1/2" sch40 inside. It makes a good hinge.


      Special Offers: See the latest Miller deals and promotions.