Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

DFW area welders

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • DFW area welders

    I am working on a project out of 1/4" plate. I had some pieces plasma cut but the design has changed slightly. I need to modify the current pieces. I need to plasma cut about 30" to get the new shape. It is all straight lines. If somebody in the area has a plasma that I could meet up with and get this taken care of, I'd be very indebted. I have used a friends plasma before but this is a tad to thick. I can supply a case of Frosty adult beverages of your choice for this help.

    Thanks in advance

    Scott

    safeprosek@gmail.com

  • #2
    1/4 Steel Plate

    I'm in Phoenix, so I guess that's out of the question. I cut 1/4" and thicker all the time with my Extreme 375. Just take it a little slower.

    Hope you find some one, O/A torch would certainly work!

    Dave

    Comment


    • #3
      I'm in Longview Tx but i work night

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.