Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Welding Table & some jeep goodies....warning picture fat!!!

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Welding Table & some jeep goodies....warning picture fat!!!

    Decided to fab up some stuff over the last few weeks!





  • #2


    Comment


    • #3

      Comment


      • #4
        Nice work, looks like you have been busy.

        Comment


        • #5
          Yeah....busy, but still fun!!

          Comment


          • #6
            great looking add on's. bet ya saved a bundle off retail, and had good fun doing it as well. great job.

            P.S. not bad load time, even on dial up they loaded fast.
            Last edited by fun4now; 01-04-2009, 02:43 AM. Reason: P.S.

            Comment


            • #7
              Love the rocker bars! Nice work.......

              Comment


              • #8
                awesome job on the fenders

                Comment


                • #9
                  Nice work on the Jeep!

                  What are you using for a tubing bender (what wall thickness tubing)

                  Tim

                  Comment


                  • #10
                    Looks good. What are you using for the pivot on your tire carrier. I built one a while back using a piece of cold rolled bar and a piece of DOM but it wants to gall badly, so I will need to cut that section off and weld on a new pivot.

                    Comment


                    • #11
                      On your table, it looks like the casters are tacked on??

                      Comment


                      • #12
                        Originally posted by walker View Post
                        Looks good. What are you using for the pivot on your tire carrier. I built one a while back using a piece of cold rolled bar and a piece of DOM but it wants to gall badly, so I will need to cut that section off and weld on a new pivot.

                        1" trailer spindle from a tractor supply (Cal-Ranch)

                        Comment


                        • #13
                          Originally posted by tasslehawf View Post
                          On your table, it looks like the casters are tacked on??
                          yes, I wasn't sure how the pneumatic tires would work.....? so I tacked then for the trial period, they only lasted a week. I have since swapped them out for some solid ones! Much...much better!!!!!

                          Comment


                          • #14
                            I like your Jeep tube doors and rockers. Want to fab some doors and tube fenders when I'm done building my tube bender. Here's a pic of my rockers and bumper:
                            Modified Warn rockers



                            Front Bumper

                            Recessed LED Lights

                            Comment


                            • #15
                              Those LED "rocklights" are a cool idea.

                              Comment

                              Working...
                              X
                              Special Offers: See the latest Miller deals and promotions.