Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

project

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • project

    Here is one of my project.Name:  b9308bd2f188fe7f9fb192b9eb0eb3bb.jpg
Views: 1
Size:  157.2 KB

    Name:  6b009bb00f976bde93d49a3b3c7c58ab.jpg
Views: 1
Size:  187.8 KB

  • #2
    Nice looking MIG welds. What is the lift table for?

    Comment


    • #3
      project

      It's a lifting hoist that i use for working on my bikes, or i use it as a welding table.

      Comment


      • #4
        Good for you! I started a table lift 4 or 5 years ago. I have almost no money into it, but I bought a handy lift clone on Craigslist for $400. I don't know if I'll finish the one I started.

        Comment


        • #5
          "Lift Table"

          JohnT: That's slick! Hey, how much do you think it weighs, and is it pretty easy to move around? Can you lay it on it's side when not in use to save space?

          Dave

          Comment


          • #6
            looks great.
            another reason having a welder around is always good.

            Comment


            • #7
              project

              Hey davedarragh,I don't know how mouch it weighs. it is kind of hevy, two pepple can put it on it's side. And as long i dont have my bike on it i can move it oround fearly easy. i realy dont have mouch money in to it sence all the material were from scrap metal that i colected, the onley money i got was on the bottle jack. to every one thanks for the reply John T.

              Comment


              • #8
                Looks good so far.

                Are you going to add some type of locking mechanism to hold it up in case the jack fails ?

                How high is it when it's all the way up ?

                How high is it when it's lowered all the way down ?

                Comment


                • #9
                  Project

                  Hey chuck, yes the hoist is done the picture that shows the jack is one that i took when i first position the jack. The jack is secure by the tention of the table. I will take another pic. to show how I plase the jack. I did it this way so i can remove it any time that the jack may go bad. the table stand about four feet high and about six in. on the lower positiom. thanks JohnT.

                  Comment

                  Working...
                  X
                  Special Offers: See the latest Miller deals and promotions.