If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
In the project pics section there is a pic of a tube bender by J.Derby. I am really interested in this project. Does anyone know how to get a hold of this person or have more info on the project. the pic is from 6-11-08.
I have purchased the same model 3 bender from www.tricktools.com, the base that is used for the one you are referring to is custom made along with the hydralic setup. but the bender is available from manufactor but the prices is over 1500.00 for just the hydralics
"If you can't mig or tig it then just stick it"
2001 millermatic 210 with spoolgun
2004 miller econotig
2007 Hypertherm pmax 600
2002 trailblazer 301g