Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Bead Roller, Modified HF

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Bead Roller, Modified HF

    Bought a HF Bead Roller a few months ago, and finally got around to beefing it up.

    If you know anything about these, they are just about worthless in the 'stock' form...you have to consider it a bead roller kit.

    I used 3/8x2 flat stock, some scrap, and a 2" tube so I could fit it in my receiver.

    I did some test panels in 18 ga.

    Works fine. Now I need practice.

    -James
    Attached Files

  • #2
    Next is to add the dc motor and controller?

    Nice work

    Comment


    • #3
      Thanks,

      I'd like to motorize it but probably won't. Unless I get a bunch of beadrolling work, which I don't see happening.

      -James

      Comment


      • #4
        nice job, looks like it should do a great job now.

        Comment


        • #5
          Looks great...nice and beefy.
          Came across this while searching for other stuff.....check it out.

          http://www.jalopyjournal.com/forum/s...ghlight=roller

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.