Announcement

Collapse
No announcement yet.

Nuts and Bolts

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Originally posted by Chuck U&R View Post
    Throw 'em all in a cement mixer.
    Add a couple gallons of water, some of that green cleaner and a shovel or two
    of gravel.
    Drink beer.
    Check progress after each beer or two.
    Progress of the Nuts and Bolts or progress of inebriation
    Ed Conley
    http://www.screamingbroccoli.net/
    MM252
    MM211
    Passport Plus w/Spool Gun
    TA185
    Miller 125c Plasma 120v
    O/A set
    SO 2020 Bender
    You can call me Bacchus

    Comment


    • #17
      it doesnt give off too much in the way of fumes but its definitely not something id leave the lid off of forever or breathe too deeply. as far as disposal id look into industrial waste disposal companies. there's companies that specialize in cleaning the sludge out of factory floor drains, oil-water separation systems, and solvent tanks that can deal with it. personally i think its the way to go if youre into chemical cleaning as it lasts a lot longer than most any solvent you can buy before it becomes nasty and a 5 gallon bucket will hold most any parts you might need done.

      Comment


      • #18
        Here's another way if you have the time to cobble it together. http://www.fordmuscle.com/forums/tec...ctrolysis.html

        Comment


        • #19
          Does all this sound worth the effort? Would likely cost about half as much to buy what you needed new.

          Comment


          • #20
            Shell reloaders use a vibrator cleaning system and they are available at I think grizzley.

            http://www.grizzly.com/catalog/2008/Main/627

            this could be a good start.

            Peace,
            Paul

            Comment

            Working...
            X