Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Rotisery < Not for cooking

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rotisery < Not for cooking

    My good ole Dynasty 300 DX, and I had some time the other day. So between the 2 of us we fab'd up some steel and built a nice little rotisery. Its not as fancy as some others. But it does everything I need it too.

    Casters are Faultess, 6" ones at the corners and 4" ones in the middle. The are all roller bearing, with grease zerks at the wheel bearing, and at the swivel. Rated for 900lbs each.


  • #2
    Nice job my friend!!

    Comment


    • #3
      Nice job , I built a set so we could work on a freinds Nova . The ones I built are were built to do more than cars .

      Comment


      • #4
        Could use a good coat of paint. Good job!

        Comment


        • #5
          I don't fancy paint much. When the car gets sand blasted , I will blast the stand and send it out for powder coat. Its uncany but the Powder coaters have a blue <star blue> thats SOO close to miller blue. My benches are miller blue currently. But it was too much work to paint, when you don't have a proper booth set up.

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.