If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Almost any AC welder can be modified to give you DC which opens up the possibility of doing TIG and also providing more selection of DC stick rods.
Many years ago I had an AC only stick welder and I added a full wave rectifier to provide DC. It required 4 large stud mount diodes with 3/4-20 threads to give you an idea of size. I also had to mount the diodes on aluminum heat sinks and insulate them so they would not short out to the welder case.
Back when I did this, I had more time than money so it was my cheap way to start.
After all was done, the welder worked quite well and I was able to TIG using the scratch start method.
After I got better, I saved up and got a used Airco heliwelder as I needed the amperage control capability.
I did the mod in 1978 and the parts cost about $50 plus about a week of work and cussing.
So, yes it can be done but what is your time worth?
Miller Dynasty 350, Dynasty 210 DX, Hypertherm 1000, Thermal Arc GTSW400, Airco Heliwelder II, oxy-fuel setup, metal cutting bandsaw, air compressor, drill press, etc.