Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Simple curtain rods...

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Simple curtain rods...

    My wife wanted to spend 40 bucks for some steel curtain rods and i said i don't think so. So some 3/8" rod and a few old steel ball bearings and wolla, hang the curtains...Bob
    Attached Files

  • #2
    Nothing like a little ingenuity to save a buck. Way to go.

    Comment


    • #3
      Can't even tell it's home made... until you pick it up!!!
      Good job!

      Comment


      • #4
        Something like this could very well be the justification I have been searching for in getting the green light on a Dynasty for hobby use out in the garage

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.