Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

e71t-1

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • e71t-1

    hints on running e71t-1 3/16 wire on 1/4 inch plate in vertical postion

  • #2
    wire welding

    the wire that we use in the feild is no bigger than 5/32 and that is
    NR-211mp lincoln wire

    the other wire we use is NR-232 and that wire is .072
    and the last one we fall back on is the good old 7018
    1/8 inch is the all out weld in any spot

    the wire you have sounds like ship yard welding that is where i
    have seen wire that size

    Comment


    • #3
      I think you mean 3/32" wire, and that'd be mighty hot and fast! Sorry, I've only run an E71T-1 1/16" wire in the vertical position, and on 1/4" plate I think I'd have troubles knowing where to set the machine to avoid meltdown. I've only run 3/32" flux core in flat and horizontal positions.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.