Announcement

Collapse
No announcement yet.

Automation for 8030 Plasma

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Automation for 8030 Plasma

    Hello all, I have a miller 8030 that I want to hook up to a CNC Plasma table. I want to know if I can add the Automation option to my 8030. I have a machine torch for the system, but I don't have the box on the back to interface it to my CNC. Any help with this would be appreciated

  • #2
    if all else fails give miller teck. guys a call. they have always been verry helpfull. if you have a machine torch i'm shore it can be done, might just need a softwhere setting.
    good luck.
    thanks for the help
    ......or..........
    hope i helped
    sigpic
    feel free to shoot me an e-mail direct i have time to chat. james@newyorkmetalart.com
    summer is here, plant a tree. if you don't have space or time to plant one sponsor some one else to plant one for you. a tree is an investment in our planet, help it out.
    JAMES

    Comment


    • #3
      You don't need a plasma table. I'll take it of you'r hands for ya for $10 and even haul it away for free.

      Comment


      • #4
        give the motorsports board a try, i know a few guys over there have plasma tables. they have talked about haveing to set the delay times on the cutter's to CNC startup. so they may be of more help.
        you will have to re-regester over on the other board again but its well werth it to have access to both boards.
        welcome to the site's .
        thanks for the help
        ......or..........
        hope i helped
        sigpic
        feel free to shoot me an e-mail direct i have time to chat. james@newyorkmetalart.com
        summer is here, plant a tree. if you don't have space or time to plant one sponsor some one else to plant one for you. a tree is an investment in our planet, help it out.
        JAMES

        Comment

        Working...
        X