Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

living room table .......almost finish

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • living room table .......almost finish

    HI

    Just to show you the table i did on friday , still some filling to do on inside corner and after that ready for placage , satin nickel , stainless steel look alike , i use CR 1 3/4 square tubing , and the glass is 22x44 inches .

    Bobby
    Attached Files

  • #2
    looks sweet but I think it would look better with larger glass so it covers it all.

    Comment


    • #3
      Very nice, I can picture lots of effort to keep it square. My tables have been much simpler and managed to weld in distortion that required straightening.

      Comment


      • #4
        i like the design of your base. nice work too

        Comment


        • #5
          Nice work.

          Please clip your pics to 800 x 600 for us dial-up guys. Thanks, Craig

          Comment


          • #6
            nice design. i suspect you have the steel larger than the glass as an art design intentionally. i would agree with it as but would add some small 1/2" rubber spacers under the glass if its not already in the works.

            love the truck in the back.
            Last edited by fun4now; 11-01-2008, 12:05 AM. Reason: truck

            Comment

            Working...
            X
            Special Offers: See the latest Miller deals and promotions.