Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Pipe Saddles Branch Fitting

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pipe Saddles Branch Fitting

    Does anyone have a good internet source for threaded pipe saddles/branch fittings? Ive done a few searches and did not come up with much. Im looking for 3" female pipe thread to weld onto 4 or 5 inch pipe.

    Thanks in advance,

    Weekend Welder

  • #2
    Depending on how good this all had to be I might weld a threaded coupling as an adapter.


    • #3
      Did you search by O-lets??

      Weld-O-lets or thread-O-lets should work too. Try with and with out dashes.


      Special Offers: See the latest Miller deals and promotions.