If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Miller Synchrowave 350LX with tigrunner
Esab 450i with wire feeder
Thermal Dynamics cutmaster 51 plasma cutter
Miller aircrafter 330 - sold
Marathon 315mm coldsaw
vertical and horizontal band saws
Dewalt cut off saw
Sand blast cabinet
lots of hand grinders
Miller 252 Mig
Miller Cricket XL
Millermatic 150 Mig
Miller Syncrowave 200 Tig
Jet Lathe and Mill
Jet 7x12 horz/vert band saw
DeWalt Multi Cutter metal saw
Century 50 Amp Plasma Cutter
20 ton electric/hydraulic vertical press
60" X 60" router/plasma table
thanks for the help
hope i helped
feel free to shoot me an e-mail direct i have time to chat. firstname.lastname@example.org summer is here, plant a tree. if you don't have space or time to plant one sponsor some one else to plant one for you. a tree is an investment in our planet, help it out.
Great looking project. Impressive to say the least.
You must have the patience of Jobe.
Syncrowave 250 DX Tigrunner
Dynasty 200 DX
Miller XMT 304 w/714D Feeder & Optima Control
Miller MM 251 w/Q300 & 30A SG
Dialarc 250 AC/DC
Hypertherm PM 600 & 1250
Wilton 7"x12" bandsaw
PC Dry Cut Saw, Dewalt Chop Saw
Milwaukee 8" Metal Cut Saw, Milwaukee Portaband.
Thermco and Smith (2) Gas Mixers
More grinders than hands
Great job all around. Looks like 2 years worth of work. Yoy should be very proud and display this where everyone can see it.
The story goes like this...we are not very good at choosing art. My wife wanted some kind of artwork for our dining room. Every time we would go shopping for a picture we would look at each other and say do you think that would look good? Then both of us would look at each other with a puzzled look. Finally she said to me make a steel wall hanging...so I did. By the way, nice buck!