Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Truck box tie down rails with toolbox

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Truck box tie down rails with toolbox

    I just built and installed a pair of tie down rails for my F350 pick up. They were made from 3/16" angle iron with hooks bent from 3/8" round bar. The first 21" back from the cab was fabbed up by notcing out vertical side of the angle iron leaveing 1 3/16" then using the excess cut off a matching section and welded up a box section to set the tool box on. The mounting bolt holes are 1/2" and the hole on the bottom of the box area has a 1 1/8" hole on top to drop the bolt through and put a socket on it.

    Here are some photos,
    Attached Files

  • #2
    Nice job on the rails, thanks for sharing

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.