Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Cylinder heads

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cylinder heads

    Hey Guys, I'm knew on here, wanted to say Hey and ask a question. I've been reading as many old post as I can, but haven't come across any on welding cylinder heads for cars,bike and tractors. ect. Can anyone give me some information on this or point me to a site where I can find it? Thanks, Willy T

  • #2
    Opps! Think I posted under the wrong category, sorry. Hope you can still point me in the right direction. Willy T

    Comment


    • #3
      This is the rod i like for stick welding. It doesn't need much pre heat and makes a nice soft weld that can be machined. Its about 25 bucks for a tube of it at my LWS...Bob
      Crown 255 Nickel Alloy Electrode for Cast Iron (E NiFe-CI)
      http://www.crownalloys.com/page10.pdf

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.