If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Your pics are a little small. I need a magnifying glass to see what youve done. Can you make the pics any bigger? How big a boat you wan tto move?
Ive got a welded alumunm and it weighs 900 pounds or so.. I have it ona trailer but last month it was capsized in the back yard so I could paint the bottom. Could of used someting other than brute strength to flip it back and reload it on the trailer..
Will it weld? I loooove electricity!
Miller 251/30A spool
Precix 5x10 CNC Router12"Z
Standard modern lathe
Cheap Chinese mill that does the trick... sort of...
horizontal 7x12 bandsaw
Roland XC540 PRO III
hammer and screwdriver (most used)
pooper scooper (2nd most used...)
The 1st pics are resized so they aren't so big to download. I tried to attach a bigger one but it is too large.
My little boat only weighs @100#. I looked all over the internet, didn't have any luck finding any plans, I just looked at some images of commercial ones. I just used some old 1" tubing to make the frame. I used some 5/8" bolts to bring the to frames snug against the transom, 1/2" rod for axle and pneumatic tires, seems to roll very easy.
Miller 140 w A/S
HF 90 Amp Flux Core
Dewalt Chop Saw
Smith O/A Torch
Ryobi, HF grinders