If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The weldpak will weld to 5/16" with multi pass
Sorry for the delay in answering. I have welded up to 1/4" with the weldpak using flux core and 3 passes (beads). For a small job you could grind a V or notch between the two plates. I really wouldn't weld anything over 3/16" that would be subject to much stress though. I later upgraded to a MM175.