Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Hyd Shaft weld on yoke

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hyd Shaft weld on yoke

    A couple pics of a project from a few days ago. it started out with customer bringing in the hyd. ram with the yoke weld broken. So we extended the ram so as to not damage the seals. 2 days later it returned as per pics. A few more questions on it & I was conviced it was way under engineered. The second break was at the top of the piston & when extended made a horseshoe of the shaft. Found out from customer that the company now uses 2.25" shaft instead of 1.75" . Still undersize as far as I am concerned because they expect one single ram to lift 64 ft. of airdril on a rockshaft. Only satisfaction here is that our weld on the yoke survived quite nicely.
    Attached Files

  • #2
    Nice fix...Bob

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.