Announcement

Collapse
No announcement yet.

Branding Iron Heaters, Porpane

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Branding Iron Heaters, Porpane

    Looking for input, ideas, plans for a shop-built branding iron heater. (for personal use) Have a piece of 8" sch40 pipe and mat'l for legs, just wondering if someone else has built something like this in the past and would like to share some tips. Also, a little puzzled about the burner I should use. Recommendations? Buy a premade burner or tips to fab one up.

  • #2
    May not help, but it sounds like the gas forges I have seen. Some even make their own. I have even seen the burner made out of pipe with holes drilled in it and capped on the end, with a gas grill regulator on the tank. Sounds kinda dangerous to me though.
    Try searching on the net for homemade forge.
    Tim Beeker,
    T-N-J Industries
    (my side bussiness)

    Miller Synchrowave 350LX with tigrunner
    Esab 450i with wire feeder
    HH135 mig
    Thermal Dynamics cutmaster 51 plasma cutter
    Miller aircrafter 330 - sold
    Marathon 315mm coldsaw
    vertical and horizontal band saws
    table saw
    Dewalt cut off saw
    Sand blast cabinet
    lots of hand grinders
    Harris torch
    beer fridge

    Comment


    • #3
      Also try searching the internet for pottery kiln construction. At one point I was going to do sand casting and was looking at building a kiln like oven to melt the steel
      Millermatic 350P
      Dynasty 350DX
      Trailblazer 302
      Spectrum 2050
      Spectrum 375 Extreme

      Comment


      • #4
        yes a gas forge would work. here are some ssites for ya to look at
        www.iforgeiron.com
        www.anvilfire.com
        and google gas forge plans .

        Inferno Forge

        Chris

        Comment


        • #5
          You could go this route, tis a mudbug cooker burner uses 3/8" nipple TBE w/a cap drilled 1/16" hole in it's top, cocked to the side so the flame hits the vert. pipe, uses no regulator. During the winter SIL stands a short pc. of 12", maybe 16" pipe in place of the cook pot and surves as a heater for his two bay muffler shop.
          Attached Files

          Comment

          Working...
          X