If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How the heck do you TIG weld with those gloves (shown with switch)? They look like something I'd use if I was running a stick at 300A. Must be a real beach to feed filler with them on.
Syncrowave 250 DX Tigrunner
Dynasty 200 DX
Miller XMT 304 w/714D Feeder & Optima Control
Miller MM 251 w/Q300 & 30A SG
Dialarc 250 AC/DC
Hypertherm PM 600 & 1250
Wilton 7"x12" bandsaw
PC Dry Cut Saw, Dewalt Chop Saw
Milwaukee 8" Metal Cut Saw, Milwaukee Portaband.
Thermco and Smith (2) Gas Mixers
More grinders than hands
Just put the final touches on the cart will get pics up tomorrow. Gonna get a strap for the Dynasty, or I was thinking of using 1/2" Al round stock and welding next to the Dynasty. Might look pretty trick. I would put some rubber over it or some rubber heat shrink to help from scratching or vibrations.
Miller Dynasty 200DX SOLD WeldTec Water Cooler SOLD Miller Millermatic 180 w/ Spoolmate 100 20Ton press And lots of Cut-off and grinding wheels www.IAGPERFORMANCE.com