Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

New to forum wanted to share some MIG projects

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • New to forum wanted to share some MIG projects

    I just joined up for some advice on my new-to-me 180SD, thought i would share some of my MIG projects

    Did a 4 1/2' X 8' trailer for my uncle used a stripped down mercury villager rear axle 3300lbs rated!, I swear you could park a tank in this thing frame is 3"x3"x1/8' square tubing! (i think i over designed it a lil)

    My Go-kart for some fun! used a 11hp honda, comet torq-a-verter series 40 primary drive and a #60 chain final drive, hydraulic disc brake mercedes benz caliper and toyota hi-lux clutch master for the brake master. Thing is soo much fun!
    Attached Files
    Last edited by Garage guy chris; 04-11-2008, 02:52 AM.

  • #2
    Put a little shovel in front of that thing and LET R RIP!!!!!!!!!!

    Comment


    • #3
      Real nice..

      Very cool. Keep the photos coming! And remember as a welder, nothing is overbuilt, unless it won't fall down.

      TacMig

      Comment


      • #4
        I could get into some serious trouble with that Kart!

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.