Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Boat lower unit repair pics.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Boat lower unit repair pics.

    I took a few pics of a boat motor I repaired yesterday.

    I had to cut out the piece of aluminum to clear that little circle shaped fin, and then weld another piece on top, and blend in in. Had a few porosity problems with that top piece, but all in all it was a easy job. I was kind of worried I'd have problems w/ the cast aluminum.

    Used the Dynasty 200dx.






  • #2
    Looks good, Just curious what you used for filler?

    Comment


    • #3
      I started to grab the 1/16 5356, but I went for the 1/8. can't remember the alloy. Probably 5356 also.

      -James

      Comment


      • #4
        Good looking repair job, ,,,,,,,,,,,,,,, B ,,,,,,,,,,,,,,,,,,

        Comment


        • #5
          looks good, should have fixed the propeller wile you had it.

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.