Announcement

Collapse
No announcement yet.

Syncwave 200 amp stick welding?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Syncwave 200 amp stick welding?

    I just purchased a Syncwave 200 and the DC stick (Dig) welding graph shows maxuim output of 300+ amp. Am I reading this graph correctly?
    Willy

  • #2
    I'll do some more checking, but its rated for 40% at 150A with a maximum output of 200A in everything I read.

    Comment


    • #3
      Where is this graph? I don't see one in the manual section which describes the dig control.

      Comment


      • #4
        I see it, page 6, section 2.7

        I don't think those would be consdered usable amps. The voltage has dropped too low at that point on the curve. It's just the mathematical possibility on the curve, is my guess.

        Comment


        • #5
          300 AMPS seems more like the max output for the Sync 250 rather than the Sync 200. As MAC stated, I think that is a theoretical number rather than what may actually be available/useable.
          Syncrowave 250 DX Tigrunner
          Dynasty 200 DX
          Miller XMT 304 w/714D Feeder & Optima Control
          Miller MM 251 w/Q300 & 30A SG
          Hobart HH187
          Dialarc 250 AC/DC
          Hypertherm PM 600 & 1250
          Wilton 7"x12" bandsaw
          PC Dry Cut Saw, Dewalt Chop Saw
          Milwaukee 8" Metal Cut Saw, Milwaukee Portaband.
          Thermco and Smith (2) Gas Mixers
          More grinders than hands

          Comment


          • #6
            Graphs

            What is the minuim voltage for dc stick welding?

            Comment

            Working...
            X