Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

burning through with the spoolmatic 3

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • burning through with the spoolmatic 3

    i just purchased a old spool matic 3 today and was using it on some alum.
    the problem is i keep burning through.. i was useing 1/8 alum checker plate not shure what grade of alum tho ,, its on a mm251.. anyone know what settings i should have it at for 1/8'' and 1/4'' alum.?

  • #2
    starting point

    with 5356 wire, 22 volts and 550 or so wire speed. go like ****


    Special Offers: See the latest Miller deals and promotions.