Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Millermatic 210

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Millermatic 210

    Hey guys

    I'm thinking of purchasing a millermatic 210 mig with aluminum spool gun for aluminum dock fabrication. Material thickness is anywhere between 1/16 and 3/8". Does anyone have this machine and do you recomend it?


  • #2
    I have the Millermatic pulser, which is basically a 210 with pulse for aluminum. I think Its now been replaced with the 350P.
    The 210 packages w/spool gun are pretty reasonable around $2100.00. The one I have works well. We have a 251 w/spool gun but also an older "200" in the shop that has a spool gun and it works very well.

    good luck


    Special Offers: See the latest Miller deals and promotions.