If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm thinking of purchasing a millermatic 210 mig with aluminum spool gun for aluminum dock fabrication. Material thickness is anywhere between 1/16 and 3/8". Does anyone have this machine and do you recomend it?
I have the Millermatic pulser, which is basically a 210 with pulse for aluminum. I think Its now been replaced with the 350P.
The 210 packages w/spool gun are pretty reasonable around $2100.00. The one I have works well. We have a 251 w/spool gun but also an older "200" in the shop that has a spool gun and it works very well.