Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Cast Iron Milling Machine table repair.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cast Iron Milling Machine table repair.

    This is a pretty common break on old milling machine tables. I fitted a chunk of copper bar under the tee slot to save machining later then i stick welded it with some 5/32 Viking Metals machinable cast rod i got cheap off ebay, wrapped it up in some insulation and let it sit a spell. It should clean up nice....Bob
    Attached Files

  • #2
    Looks good Bob thanks for sharing

    Comment


    • #3
      Hey Bob,
      saw all your pics off your photo show...SWEET!!! 'Far as this table, top can be grinded down normally, but how will you grind down the sides to match the rest of it?
      thanks,
      bert

      Comment


      • #4
        Bob

        Could you post a picture of the rest of the machine? You did a really nice job. I may have used nickle rods if this is really cast iron, just a thought.

        Jerry

        Comment


        • #5
          Here is a pic of the whole machine. I just welded it for the owner and he is going to have it reground. Internet welding job . I used cast iron welding rods that are 100% machinable and the color should match pretty good...Bob
          Attached Files

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.