If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
48x 48 x 1" thick, has lots of overhang to clamp stuff to. 1 foot is adjustable to take any rock out of it. Each leg has a holder for the tig torch.
Next time the only thing I would do different is, make it 48 x 96, and instead of the cross bracing currently going around the outside of the bench at the bottom. Would be to run them diagonally into the center, and have the lower "foot rail" in about another 6 inches. This will allow more room for the foot pedal.
MM 130 110v Mig
Spectrum Cutmate 300 110v/240v Plasma
Syncrowave 250 Tig, oldie but welds nice
Dynasty 300 DX Tig, very nice machine, AC doesn't start most of the time