Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

weld table

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • weld table

    anybody have some pics of a heavy duty welding table? I would like some ideas for my new one.

  • #2
    In the foreground you can see part of ONE of our tables. It's a skeleton design, which we favor for most of our fabrication work, made of 3" x 3" x 5/16" angle.
    Attached Files

    Comment


    • #3
      This time you can see a different table in the background made of the same material. Sorry these really aren't table pics, but maybe you can see enough of them to at least see what we are using.
      Attached Files

      Comment


      • #4
        It is not a welding table but I use it for a workbench and a welding table. I always weld jigs to it.

        tjsperformance.com/workbench.htm
        Last edited by envano; 08-21-2007, 02:06 PM. Reason: broken link

        Comment


        • #5
          No pics but my table has a 1" thick x 48" x 96" top. It is 32" from floor to the top surface. It has a 4" ship channel frame with 6" HD casters.---MMW---

          edit-- Don't forget to leave an overhang for clamping stuff.
          Last edited by MMW; 01-23-2006, 07:37 PM.

          Comment


          • #6
            nice tables

            Loks like Mac has some nice tables..I'm sure they come in handy.
            Farris

            Comment


            • #7
              Table

              Here is a pic of my welding table
              http://groups.msn.com/holyshift/52ma...o&PhotoID=1023

              48x 48 x 1" thick, has lots of overhang to clamp stuff to. 1 foot is adjustable to take any rock out of it. Each leg has a holder for the tig torch.

              Next time the only thing I would do different is, make it 48 x 96, and instead of the cross bracing currently going around the outside of the bench at the bottom. Would be to run them diagonally into the center, and have the lower "foot rail" in about another 6 inches. This will allow more room for the foot pedal.

              Comment


              • #8
                over hang

                You're right a person needs to remember to leave some overhang for clamping..
                Thanks, farris

                Comment

                Working...
                X
                Special Offers: See the latest Miller deals and promotions.