Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Dynasty 200 DX Local and Remote

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dynasty 200 DX Local and Remote

    I reacently purchased a Dynasty 200 DX and would like to hook up a contactor switch (on/off) like I use at work, but i can't fiugure out how to make the machine run Local/Panel and not in Remote? I read through the manual and the closest I have come is messing with the RMT2 settings. I run a syncrowave 350 with the same switch at work and that machine has a toggle switch for local and remote but not on the dynasty. I would really appreciate the help. AL
    Last edited by beau; 03-26-2007, 03:54 PM.
Special Offers: See the latest Miller deals and promotions.