Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

new tig for me: syncrowave 180sd? or dynasty 200 dx?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • new tig for me: syncrowave 180sd? or dynasty 200 dx?

    hi all.. i have been thinking of getting a tig machine for a while now and both of these look like a good machine to me. i like the syncrowave 180 as it is cheaper than the dynasty 200, but the dynasty is so much lighter [and i could run it off 120v if i take it out of the shop]

    what are some other good and bad points of these machines

    most of my welding with it will be on mild steel from 20g to 1/4" and maybe some aluminum and stainless later on [i rarely work with either now]

    any comments on these machines from those who use them/own them???

  • #2
    i bought a syncrowave the other day and have no complaints yet, its a great machine

    Comment


    • #3
      If you are leaning toward a Syncrowave, I would wait until the 200 replaces the 180 shortly. Looks like it has some nice features.

      Comment


      • #4
        I got the Dynasty. It's a great machine. Great w/aluminum being able to wide range adjust the freq for each different work desired. Nice to be able to run on 120 for light duty jobs. Low amp requirement to run, so does not need a dedicated electrical outlet. Cons...Dig deep into your pocket. If space is a premium an inverter is the your answer...HTH somewhat...

        Comment


        • #5
          Syncrowave 180

          I bought the syncrowave 180 last year and I have been very happy with it. I am far from an expert, but I found it very easy to use, and I got great welds for a beginner. I don't have any experience with the other machine you mentioned. Keep in mind that if you want to weld thick aluminum, you may be pushing the limits of the 180. Aluminum sinks alot of heat. In the range you mentioned you will be fine. If you do weld thicker aluminum later once in a while you could just preheat to get by. If you can afford it I would go with the 250

          scottw

          Comment

          Working...
          X
          Special Offers: See the latest Miller deals and promotions.