Announcement

Collapse
No announcement yet.

Question about Synchrowave 200

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Question about Synchrowave 200

    I've found a low hours syncrowave 200 at a good price. The question I have, is there a "remote" switch that I don't see? I had a synchrowave 250 that had switch to allow for a remote (foot pedal) or to set the amps at the machine for use with a finger switch. I need to use a finger switch but I'm not sure how. Thanks.

  • #2
    When you select TIG on the process selector switch, output is controlled via the 14-pin connector, just plug in whatever remote you want to use.

    Comment


    • #3
      Thank you sir.

      Comment


      • #4
        You're quite welcome. Hope the Sync 200 serves you well. If you get the serial number from the welder, you can download a manual for free under the "Support" link on this site. (Bottom of that s page).

        Comment

        Working...
        X