Announcement

Collapse
No announcement yet.

Miller Dynasty 200 reads 0.0 on voltage meter in stick mode after doing factory reset

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Miller Dynasty 200 reads 0.0 on voltage meter in stick mode after doing factory reset

    Will not stick weld in stick mode AC or DC and has 0.0 on volt meter the only mode volt meter shows voltage is in tig-lift

  • #2
    Originally posted by jimbobrat44 View Post
    Will not stick weld in stick mode AC or DC and has 0.0 on volt meter the only mode volt meter shows voltage is in tig-lift
    More info needed.


    Griff

    Comment


    • #3
      When you open it up are the single phase back and white primary on 1 & 2 left to right black and white, orrrr?

      Comment


      • #4
        Yes black 1 WHITE 2 IT WAS WORKING FINE THEN DID A FACTORY RESET AND AFTER THAT IT VOLTAGE STARTED READING 0.0 VOLTS AND WILL NOT DO ANYTHING

        Comment

        Working...
        X