Announcement

Collapse
No announcement yet.

Part number for engine wiring harness - TB302?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Part number for engine wiring harness - TB302?

    Driving to the job site today, I heard my TB-302 cranking. Pulled over and long story short, a squirrel chewed the engine wiring harness almost in half. Right where the harness plugs into the bulkhead connection. I got in at the rear mounting access hole. Made blank covers for the holes today.

    I need the part number for the harness so, I can order a new one. Don't want to splice it.

    Thanks,

    Mike

  • #2
    Get your serial number and download the correct parts manual.

    http://www.millerwelds.com/service/l...ER%20302%20GAS

    Comment


    • #3
      Miller doesn't offer the engine side wiring harness. At least not in their parts break-down. Only the harnesses in the welder/generator.

      Is there enough slack in the wires to allow installing new terminals for the connector?
      Last edited by duaneb55; 04-09-2014, 03:45 PM.
      MM200 w/spot controller and Spoolmatic 1
      Syncrowave 180 SD
      Bobcat 225G Plus LPG/NG w/14-pin*
      *Homemade Suitcase Wire Feeder
      *HF-251D-1
      *WC-1S & Spoolmatic 1
      PakMaster 100XL
      Marquette "Star Jet" 21-110

      Comment

      Working...
      X