If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
AK- you never mentioned if you actually switched the wires INSIDE the machie
Remove the sleeving from both leads.
6. Connect the large lead to push-on terminal
labeled “3” on the adjacent PC board.
7. Connect the small lead to terminal 15 of the line
8. Reposition insulation to cover line switch.
9. Re-install wraparound.
10. Move the lock pin to allow switch movement for 230 V selection only.