Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Problem with Dynasty 300DX

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Problem with Dynasty 300DX

    My Dynasty 300DX gives me a trouble code of HEL-6
    I'm running it on 480 volt 3phase. My meter tells me that I have 480 volts across each leg with about 278 volts between each leg to ground. Voltages were measured at the wires going into the welder.
    The trouble code tells me that the input voltage is low. I certainly don't measure any low voltages.

    Any suggestions?

    Thanks

  • #2
    Well, we never check voltages to frame ground, that means nothing and is kinda a dumb idea due to board circuit commons., more thinking that your top board is cooked

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.