Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Big 40 Diesel

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Big 40 Diesel

    Ser. # JJ404151 1988 with CV-2
    New to me and just noticed that the
    D-C Volt gauge shows voltage wile not welding in DC elect Neg. and AC but when switch to DC elect Pos. shows no voltage on gauge. Seems to weld fine in DC elect Pos and shows Amps at gauge but shows no Volts while not welding. As it does in both other modes. Just wondering if I hv problem or normal ?
    Thx Greg

  • #2
    Its direct read, or relay is buggered. Seems obvious

    Comment


    • #3
      Big 40 Diesel

      Ok. Kinda what I thought. Just wanted to ask before I started digging to deep.
      Thx Cruizer

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.