Announcement

Collapse
No announcement yet.

Spoolmatic2 ,wc3 stuck on run in speed

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spoolmatic2 ,wc3 stuck on run in speed

    I have a Spoolmatic 2 and a WC3 that I just purchased. When I pull the trigger it feeds but, when I release the trigger it stays on slow ( run in) speed. It will stop only when I turn off the controller. Thanks

    I was able to figure it out. The trigger return wasn't wasn't pulling back strong enough to switch off.
    Last edited by 3dcycle.blogspot; 01-05-2014, 09:46 AM.
Working...
X