Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

TIG welding near airport with high frequency

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • TIG welding near airport with high frequency

    I plan to use a Hobart 1611 high frequency arc stabilizer very near an international runway. Would it cause any communication problems with aircraft?
    I read once that the FCC disapproves of this. Any info. much appreciated.
    I love this website !

  • #2
    I would not expect it to bother anything or to have enough amplitude or be on a frequency that would matter.. unless it is inside the airplane

    how close would you be to the aircraft??

    Comment


    • #3
      As a retired airline pilot and an aircraft mechanic, I guarantee you if there is any interference they will let you know about. Shouldn't be any problem. I used cellphones etc. in the cockpit for years without interference.

      Comment


      • #4
        I have seen an awful lot of TIG machines in hangers over the years...

        Comment


        • #5
          I doubt it's a problem. Cell phones etc causing interference with airplanes is overrated and unsubstantiated. In fact i have read a few articles that the FAA was planning to lift the cell phone ban in commercial airplanes.

          Comment


          • #6
            My father in law texted me recently from the air just because he was allowed to.

            Comment


            • #7
              Shop I used to work at was on the airports airfield. Never had an issue.

              Comment


              • #8
                Air Force bases have TIG machines aplenty and some are fairly near the flight line.

                I've never heard of any problems when I was a Comm/Nav troop.

                Comment

                Working...
                X
                Special Offers: See the latest Miller deals and promotions.