Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

REQ: Maxstar 152 - PC-300 info

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • REQ: Maxstar 152 - PC-300 info


    1. Has anyone connected the PC-300 directly to the Maxstar 152 for power? Since the Snap Start II can do this I think the PC-300 should be able to do this also.

    2. Has anyone found a good way to attach the PC-300 to the Maxstar 152 in a manner similar to the Snap Start II?


  • #2
    Probably work, though you have no HF, and thats used for the pulsing action. Not sure if the arc would stay alive , cause you'd likely have no background voltage either. Try it and see. Can't hurt anything...


    Special Offers: See the latest Miller deals and promotions.