Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

needing a test schematic for xmt 304

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • needing a test schematic for xmt 304

    High all new to site looking for a test schematic for main board on a xmt 304 serial # Kj074271. Got a bad switch plus I think a diode burned on the board. As soon as i turn it on it blows main breaker its wired up single phase also any help would b great! Thanks in advance

  • #2
    Other than a occasional pulse transformer, the main board will not blow the breaker. More likely your input bridge (SR1) ,your output board and igbts are fizzled. Best look at them first.

    Comment


    • #3
      Ok thanks I'll do that first!

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.