If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Did you look up the wire manufacturers specs & parameters for the wire you are using? That should be your starting point. Also check your machines feed for accuracy, ie physically measure the inches per minute to make sure it jives with the knob.
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
One thing you can do is download the welding calculator app from this website. Go to the resources tab and click on weld calculators and there will be an app that can be downloaded to your smartphone and always be available to you.