After searching here in the forums and not finding exactly what I was hoping for or at least not like my setup, I was hoping for some guidance for hooking up my autoset 211 for 220 service. I do have the MVP plug setup.
What it is I am trying to do is run my Autoset 211 from a distance of no more than 100ft from the breaker panel. I need some help on choosing the correct type and gauge of cable for my 211. I need to be obviously safe to me, the house, and of course the welder. Any information on a particular type of termination at the end of my cable at the welder end would be great as well. Also, what about a gauge of extension cord for the 110 operation? Again, no more than 100 ft from the breaker panel.
Thank you all for your help.
Thank you for your help and time.