Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

press brake fab.

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • press brake fab.

    I came across 4' pieces of press brake punch & die. I also have tons of hydraulics, 2'' thick steel plates and other good stuff jus lying around. I was looking at my buddys baileigh pb-3142nc brake and i know i could build one of those in a couple days work and the stuff i already have. Ima make it to press maximum length 4' of 1/4'' steel. i might jus do it this weekend. Any takers on drinkin a few beers and tinkering in my shop for a weekend then lemme know. We always like new people... well... not always but usually
Working...
X
Special Offers: See the latest Miller deals and promotions.