Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

375 extreme plasma cutter problem

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • 375 extreme plasma cutter problem

    My 375 extreme(black torch) I have owned for several years now wont start the pilot arc, I fired it up one day and it spit out a few weird sparks but not the normal plasma, then nothing, just air. No lights on but the normal power indicator, and it will try to start/spark if I touch the tip to the grounded work, but not cut. I checked the tip and it was well worn so I ordered some new ones. Well, installed a new tip and nozzle yesterday and same thing, any ideas? Thanks in advance. The unit looks like the one in the link below:
    http://www.equipmentworld.com/articl...0-spectrum.jpg
Working...
X
Special Offers: See the latest Miller deals and promotions.