Announcement

Collapse
No announcement yet.

Hobart RC 300

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hobart RC 300

    I have an old RC 300 Hobart power source with an Hobart 27 might wire feeder. This is a nice machine for its age and hate to scrap it but the coarse voltage selector is broken. The aluminum spider that the handle engages is broken and would like to replace it. Anyone know where I could find this at? Thanks
    Syncrowave 350lx
    XMT 350 CC/CV
    S74DX Feeder
    30a spoolgun
    Hypertherm 1000 g3
    Harris O/A
    Cincinnati lathe
    Acer Ultima "Bridgeport Mill"
    340hp Quincy and 400 gallon of air
    Other doodads and a stoker coal stove

  • #2
    If you have or can get a photo of the broken part, post it. Put a tape measure in the photo to give some reference as to the size. If no one has the part can you build one yourself or have someone else build it?---Meltedmetal

    Comment


    • #3
      Unlikely to find one. What I have done in the past is to drill and tap the center with a mating piece. Tack it, and install a knob. Easy peasy...

      Comment


      • #4
        Thanks cruiser. I tigged it up and rebored it. Gonna throw it on the mill tomorrow and mill the slots back in it. Hopefully its hard enough. If it shears off I'll try and fix it with a strap and drill andtap it
        Syncrowave 350lx
        XMT 350 CC/CV
        S74DX Feeder
        30a spoolgun
        Hypertherm 1000 g3
        Harris O/A
        Cincinnati lathe
        Acer Ultima "Bridgeport Mill"
        340hp Quincy and 400 gallon of air
        Other doodads and a stoker coal stove

        Comment

        Working...
        X