Announcement

Collapse
No announcement yet.

dynasty 350 no pre post after weld stops

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • dynasty 350 no pre post after weld stops

    i was out welding tonight and ran a few small welds then go to restart and no pre or post flow then wait 5 mins or so then it will start again but after u stop again it wont start what gives here ?

  • #2
    Originally posted by mikesystem View Post
    i was out welding tonight and ran a few small welds then go to restart and no pre or post flow then wait 5 mins or so then it will start again but after u stop again it wont start what gives here ?
    Any codes thrown up at all? Only time I have had that is when a power spike locked up the machine. I shut down, restarted and was fine. Also sometimes my finger controller is on when it should be off, and machine locks up.

    Only thing I can recommend is check your remote current/panel control.

    Did it ever straighten out?
    Nothing welded, Nothing gained

    Miller Dynasty700DX
    3 ea. Miller Dynasty350DX
    Miller Dynasty200DX
    ThermalArc 400 GTSW
    MillerMatic350P
    MillerMatic200 with spoolgun
    MKCobraMig260
    Lincoln SP-170T
    Linde UCC305 (sold 2011)
    Hypertherm 1250
    Hypertherm 800
    PlasmaCam CNC cutter
    Fadal Toolroom CNC Mill
    SiberHegner CNC Mill
    2 ea. Bridgeport
    LeBlond 15" Lathe
    Haberle 18" Cold Saw
    Doringer 14" Cold Saw
    6 foot x 12 foot Mojave granite

    Comment

    Working...
    X